B.2.3 Connecting NCS to EMC filter module.................................................................................319
B.2.4 Commissioning of NCS ........................................................................................................320
B.2.4.1 Prerequisites / default settings .............................................................................................320
B.2.4.2 Initialization of part-turn actuators ........................................................................................321
B.2.4.3 Initializing linear actuators with a stroke range up to 14 mm (0.55 inch) .............................321
B.2.4.4 Initializing linear actuators with a stroke range > 14 mm (0.55 inch) ...................................321
B.2.5 Technical specifications NCS...............................................................................................321
B.2.6 Dimensional drawing of non-contacting sensor ...................................................................323
B.2.7 NCS sensor scope of delivery..............................................................................................323
B.2.7.1 Scope of delivery of NCS for part-turn actuators .................................................................323
B.2.7.2 Scope of delivery of NCS for linear actuators up to 14 mm (0.55 inch) . .............................324
B.2.7.3 Scope of delivery of NCS for linear actuators > 14 mm (0.55 inch) . ...................................324
B.3 External position detection system.......................................................................................325
B.3.1 Principle of operation of external position detection system ................................................325
B.3.2 Connecting the external position detection system to the EMC filter module ......................325
B.3.3 Technical specifications of the external position detection system ......................................326
B.3.4 Scope of delivery of external position detection system ......................................................326
C Pressure gauge block...............................................................................................................................329
D Sealing plug / thread adapter ...................................................................................................................331
D.1 Intended use of accessory part ............................................................................................331
D.2 Safety instructions for accessory part ..................................................................................331
D.3 Technical specifications of accessory part...........................................................................332
D.4 Dimension drawing for accessory part .................................................................................333
E Booster .....................................................................................................................................................335
E.1 Increased sound pressure level ...........................................................................................335
E.2 Booster introduction .............................................................................................................335
E.3 Operating principle of booster ..............................................................................................336
E.4 Mounting booster, without flameproof enclosure .................................................................337
E.5 Booster mounting, flameproof enclosure .............................................................................341
E.6 Booster commissioning ........................................................................................................345
E.7 RUN 3 and 4 sequence (booster) ........................................................................................347
E.8 Booster dimension drawings ................................................................................................348
E.8.1 For positioners in non-flameproof enclosure........................................................................348
E.8.2 For positioners in flameproof enclosure ...............................................................................349
E.9 Technical specifications of booster ......................................................................................349
F Positioner with remote control electronics ................................................................................................351
F.1 Introduction ..........................................................................................................................351
F.2 19" slide-in module...............................................................................................................352
F.2.1 Commissioning positioner 6DR5910-... and 19" slide-in module .........................................352
F.2.2 Connecting the positioner to the 19" slide-in module ..........................................................354
F.2.3 Connecting multiple positioners ...........................................................................................356
F.2.4 PA cable connection for bus connection ..............................................................................357
Table of contents
SIPART PS2 with PROFIBUS PA
Operating Instructions, 05/2019, A5E00127926-AC 11
To Next Page
Loading...
Need help?
General
