Siemens SIPART PS2 User Manual

13.2 Pneumatic data
See also
Lever for position detection (Page 107)
13.3 Construction
13.4 Controller
Controller
Control unit
● Five-point controller
Adaptive
● Dead zone
dEbA = auto Adaptive
dEbA = 0.1 ... 10 % Can be set as fixed value
Analog-to-digital converter
● Scanning time
10 ms
● Resolution
≤ 0,05 %
● Transmission error
≤ 0,2 %
● Temperature influence
≤ 0.1 %/10 K (≤ 0.1 %/18 °F)
13.5 Explosion protection
13.5.1 Breakdown of the article numbers
Each device has a nameplate. This nameplate shows a specific article number for the device.
Lower-case letters are used and explained in the tables below for the variable digits in the
article number. Each variable that is used stands for a different order version. You will find the
order data in the FI 01 catalog on the Internet.
Table 13-1 Article number

'5
D\E



FGHIJ

K=MMM
Technical data
13.5 Explosion protection
SIPART PS2 with PROFIBUS PA
282 Operating Instructions, 05/2019, A5E00127926-AC

Siemens SIPART PS2 Specifications

General

Supply Pressure	1.4 to 7 bar (20 to 100 psi)
Enclosure Rating	IP66/NEMA 4X
Communication Protocols	HART, PROFIBUS PA, FOUNDATION Fieldbus
Output Pressure	0 to 100% of supply pressure
Hazardous Area Certification	ATEX, IECEx, FM, CSA
Type	Electropneumatic
Input Signal	4-20 mA
Rotation Angle	30° to 90°
Operating Temperature	-40°C to +80°C
Mounting	Linear and rotary actuators
Air Consumption	Typically less than 0.1 kg/h