Siemens SIPART PS2 User Manual

In the "Diagnostics" tab you can find:
● Communication
● Last test
● Message text
"Communication" tab
In this "Communication" tab you can display the address of a device. If the device has been
configured in the process device network view, you can change the address.
In the "Communication" tab you can find:
● Redundancy
"Document manager" tab
In this "Document manager" tab, you can assign documents to a PDM object.
9.2.2.6 Calibration report
The "Calibration report" section contains information on the following topics:
"Test environment" tab
In this "Test environment" tab you can find:
● Data on the field device
● Data on the operator and test date of the calibration report
● Operator remarks concerning the test
● Comment field
● Settings for scheduling
"Diagnostics" tab
In this "Diagnostics" tab you can find:
● Information on display of the communication connection status
● Information on display of the device status
● Date of the last change
● Messages of the last test
Functions/operations using PROFIBUS PA
9.2 Acyclic data transfer
SIPART PS2 with PROFIBUS PA
192 Operating Instructions, 05/2019, A5E00127926-AC

Siemens SIPART PS2 Specifications

General

Supply Pressure	1.4 to 7 bar (20 to 100 psi)
Enclosure Rating	IP66/NEMA 4X
Communication Protocols	HART, PROFIBUS PA, FOUNDATION Fieldbus
Output Pressure	0 to 100% of supply pressure
Hazardous Area Certification	ATEX, IECEx, FM, CSA
Type	Electropneumatic
Input Signal	4-20 mA
Rotation Angle	30° to 90°
Operating Temperature	-40°C to +80°C
Mounting	Linear and rotary actuators
Air Consumption	Typically less than 0.1 kg/h