Siemens SIPART PS2 User Manual

B.2.2.2 Mounting on linear actuator up to 14 mm (0.55 inch)
Requirement
1. An EMC filter module in the positioner.
2. An NCS for linear actuators up to 14 mm (0.55 inch) 6DR4004-.N.20.
3. A linear actuator with interface to NAMUR. This installation must be carried out individually.
Only a NAMUR mounting bracket can be used as mounting base. The following figure
shows the assembly with NAMUR mounting bracket. Or:
A linear actuator without interface to NAMUR and individual mounting solution.
You can find the dimensions of the NCS as well as the NCS magnet under Dimensional drawing
of non-contacting sensor (Page 323).
External position detection
B.2 Non-Contacting Sensor
SIPART PS2 with PROFIBUS PA
314 Operating Instructions, 05/2019, A5E00127926-AC

Siemens SIPART PS2 Specifications

General

Supply Pressure	1.4 to 7 bar (20 to 100 psi)
Enclosure Rating	IP66/NEMA 4X
Communication Protocols	HART, PROFIBUS PA, FOUNDATION Fieldbus
Output Pressure	0 to 100% of supply pressure
Hazardous Area Certification	ATEX, IECEx, FM, CSA
Type	Electropneumatic
Input Signal	4-20 mA
Rotation Angle	30° to 90°
Operating Temperature	-40°C to +80°C
Mounting	Linear and rotary actuators
Air Consumption	Typically less than 0.1 kg/h