WARNING
Loss of safety of device with type of protection "Intrinsic safety Ex i"
If the device or its components have already been operated in non-intrinsically safe circuits or
the electrical specifications have not been observed, the safety of the device is no longer
ensured for use in hazardous areas. There is a risk of explosion.
● Connect the device with type of protection "Intrinsic safety" solely to an intrinsically safe
circuit.
● Observe the specifications for the electrical data on the certificate and/or in Technical data
(Page 281).
Safety information
2.7 Use in hazardous areas
SIPART PS2 with PROFIBUS PA
22 Operating Instructions, 05/2019, A5E00127926-AC
To Next Page
Loading...
