Siemens SIRIUS 3RK3 - Page 317

Byte po‐
sition
Message Meaning Element status Cyclic data
8
1
Start condition not ful󹪝l‐
led
is set if:
• A sensor test was not execu‐
ted in the case of an active
startup test function
• A discrepancy condition viola‐
tion is present
• The value "1" is not present si‐
multaneously at all available
(parameterized) function in‐
puts (IN1, ...)
• A signal sequence violation is
present
• A cross-circuit is present in the
case of cross-circuit monitor‐
ing
‑ ‑
8
2
... 8
7
Reserved=0
Message for protective door with lock
The following table shows the messages with the associated byte arrangement in the element
data block of the "protective door with lock" function element.
Byte posi‐
tion
Message Meaning Element status Cyclic data
6
0
Startup test required This message is set in a parameterized
startup test on each restart and each
time the substitute value is changed
to a real value until the connected
sensor is actuated at least once.
SVW SVW
6
1
Sequence condition not ful‐
󹪝lled
The sequence condition was not ful‐
󹪝lled in accordance with the parame‐
ter assignment.
Logic error SF
6
2
Discrepancy condition vio‐
lated
is set if:
• After the discrepancy time has
elapsed, the signal states at the
inputs monitored are di󹪜erent
• The signal states of the inputs
monitored had not all previously
been reset simultaneously to the
value "0" when they are set to "1"
Logic error SF
6
3
Safety sensor triggered The safety sensor has been actuated. SVW SVW
6
4
Protective door closed The protective door is closed. ‑ ‑
6
5
Reserved=0
6
6
Lock engaged The lock is engaged. ‑ ‑
6
7
Lock released The lock is released. ‑ ‑
7
0
Cross-circuit at input 1 A cross-circuit was detected at input 1. Wiring error SF
Diagnostics / service
7.6 Diagnosis using AS-Interface (CTT2 protocol)
SIRIUS 3RK3 Modular Safety System
Equipment Manual, 07/2020, NEB926253002000/RS-AC/006 317