Siemens SIRIUS 3RK3 - Page 336

Group errors ③
The following group errors can be diagnosed:
Message Meaning(s)
Con󹪝guration error
1)
• Memory module not plugged in
• SC con󹪝guration error
3)
• Memory module defective
• Memory module too small
Con󹪝guration error
1)
An error occurred during the con󹪝guration phase:
• Release denied due to incorrect con󹪝guration CRC
• Release canceled due to incorrect con󹪝guration release CRC
• Max. number of elements exceeded
• Max. size of memory exceeded
• Program cycle time exceeded
• TARGET≠ACTUAL con󹪝guration
• TARGET≠ACTUAL slot expanded con󹪝guration
• Invalid parameter value
• Interconnection rule violated
• Data structure incorrect
Safety protocol error
4)
• Multiple ASIsafe code tables
4)
• ASIsafe 8x4-bit code sequence error
4)
• ASIsafe 7x4-bit code sequence error
4)
Wiring error
2)
Faulty wiring of a sensor connection or in the sensor itself.
Logic error
2)
Protection fault: Processing sequence on the sensor not coherent.
Handshake error An error was detected during connection monitoring in test mode.
Group error from user pro‐
gram
2)
At least one error from the user program is present.
SC bus error
3)
Communication via the system interface is interrupted.
3)
SC con󹪝guration error
3)
The actual con󹪝guration of an existing communication connection does
not match the target con󹪝guration. This resulted in an error.
3)
Memory module defective Memory module is defective.
User memory too small More con󹪝guration data were transferred to the safety relay than can be
stored in the con󹪝guration memory.
1)
Di󹪜erent error causes are possible. The cause is displayed by pressing the right key (OK).
2)
Pressing the right key (OK) switches the diagnostics display directly to the relevant function element in
the status menu.
3)
3RK3 only
4)
3RK3 Advanced and 3RK3 ASIsafe only
Diagnostics / service
7.7 Diagnostics with diagnostics display
SIRIUS 3RK3 Modular Safety System
336 Equipment Manual, 07/2020, NEB926253002000/RS-AC/006