What to do if Siemens Measuring Instruments show 'Invalid Setup (use Direct Mount)'?
If your Siemens Measuring Instruments display 'Invalid Setup (use Direct Mount)', and selecting Direct Mode doesn't fix it, check all site setup and transducer installation choices. Pay close attention to the data entered for the pipe and liquid.
General| Type | Electromagnetic Flow Meter |
|---|---|
| Accuracy | ±0.2% of measured value |
| Nominal Diameter | DN 2 to DN 3000 |
| Output | 4-20 mA, Pulse, HART, PROFIBUS PA/DP, Foundation Fieldbus |
| Power Supply | 24 V DC |
| Protection Class | IP67, IP68 |
| Housing Material | Aluminum, Stainless Steel |
| Lining Material | PTFE, PFA, Hard Rubber |
| Electrode Material | Stainless Steel, Hastelloy, Platinum, Tantalum |
Crucial safety guidelines and recommendations for experienced personnel during installation and operation.
Provides a step-by-step procedure for the typical installation of the energy meter.
Guide to accessing, navigating, and entering data within the Installation Menu.
Menu for managing site setups, including creating, recalling, deleting, and saving sites.
Allows definition of application pipe parameters like class, size, material, and thickness.
Menu to edit default settings matching the application, including liquid properties.
Guides transducer selection, mounting mode, and spacing based on pipe and application data.
Preliminary steps before mounting transducers, including location selection and pipe preparation.
Guidelines for installing temperature sensors for accurate differential measurement.
Guidance on contacting Siemens for technical assistance and utilizing diagnostic data.
Information on pipe materials, dimensions, and their impact on clamp-on transducer performance.
Step-by-step guide for setting up the FUE1010EN for flow tube operation.
Details two mounting configurations: Adjacent and In-Line for Reflexor mode.
Procedure to access the menu for transducer selection and installation.
Tool for determining installation adequacy and adjusting application-dependent parameters.
To Next Page