Troubleshooting
10.5 Force Transmit
FUE1010 IP65 NEMA 4X
168 Operating Instructions, 12/2014, A5E03086491-AC
2. A typical menu screen will appear as shown below and indicate the current ALC (e.g.,
50). This ALC number indicates the current receive signal strength and can be used for
further diagnostic purposes.
3. To exit Force Transmit, press the <Left Arrow> and a Detection Fault prompt will appear
(see above).
4. Press the <Left Arrow> again and the meter will return to the [Install Sensor] menu and
highlight the [Empty Pipe Set] menu cell.
To Next Page
Loading...
