Siemens SIWAREX WP231 - Page 4

Table of contents
SIWAREX WP231
4 Manual, 07/2014, A5E31238908A-02
6 Connection ........................................................................................................................................... 29
6.1 Overview ................................................................................................................................ 29
6.2 24 V connection ..................................................................................................................... 30
6.3 Connecting the load cells ....................................................................................................... 30
6.4 Shield connection ................................................................................................................... 32
6.5 Connection of digital outputs (4 x DQ) ................................................................................... 35
6.6 Connection of digital inputs (4 x DI) ....................................................................................... 36
6.7 Connection of the analog output (1 x AQ) ............................................................................. 37
6.8 Connection of RS485 serial interface .................................................................................... 38
6.9 Connection of Siebert display via RS485 .............................................................................. 39
6.10 Connection of the Ethernet interface ..................................................................................... 40
6.11 Activation of write protection .................................................................................................. 41
6.12 Mounting of the calibration protection plate ........................................................................... 42
7 Commissioning ..................................................................................................................................... 43
7.1 Introduction ............................................................................................................................ 43
7.2 Factory-set parameters .......................................................................................................... 43
7.3 Factory setting of the mode selector ...................................................................................... 44
7.4 Commissioning tools .............................................................................................................. 44
7.5 5 minute quick start with the operator panel and the Ready-for-Use software ...................... 45
7.5.1 Start ........................................................................................................................................ 45
7.5.2 Standard parameter settings .................................................................................................. 46
7.5.3 Selecting the calibration method ............................................................................................ 47
7.5.4 Defining the calibration weights ............................................................................................. 48
7.5.5 Setting calibration points ........................................................................................................ 49
7.5.6 Calibrating the scale automatically ........................................................................................ 50
7.5.7 Performing the automatic calibration ..................................................................................... 51
7.5.8 Checking the scale following calibration ................................................................................ 51
7.6 5 minute quick setup with SIWATOOL................................................................................... 52
7.6.1 Activate service mode ............................................................................................................ 52
7.6.2 Load standard parameters ..................................................................................................... 52
7.6.3 Input of required parameters .................................................................................................. 53
7.6.4 Complete automatic calibration .............................................................................................. 53
7.6.5 Receive all data...................................................................................................................... 54
7.6.6 Checking the scale following calibration ................................................................................ 54