Siemens SIWAREX WP231 - Command lists; Overview

SIWAREX WP231
Manual, 07/2014, A5E31238908A-02
139
Command lists
10
10.1
Overview
The commands for the electronic weighing system described here can be transmitted by
several interfaces:
● by the Operator Panel via the controller to the SIWAREX module
● by the Operator Panel directly to the SIWAREX module
● by SIWATOOL directly to the SIWAREX module
● by the digital inputs after corresponding assignment in data record DR 7
A data or command error is signaled if a command cannot be executed or if the sent data
record is rejected.
Detailed descriptions of the commands can be found in the following command lists:
→ Table 10-1 Commands 1 ... 99: Service commands (Page 140)
→ Table 10-2 Commands 400 ... 449; log commands, statistics, logbook (Page 141)
→ Table 10-3 Commands 450 ... 499: Trace commands (Page 141)
→ Table 10-4 Commands 700 to 899: HMI display switching (Page 141)
→ Table 10-5 Commands 1000 ... : Basic functions for weighing commands (Page 143)
→ Table 10-6 Command groups of the SIWAREX WP231 (Page 144)
See also
Command lists (Page 140)