Siemens SIWAREX WP231 - Messages by Leds on the Module

Messages
9.5 Message list
SIWAREX WP231
Manual, 07/2014, A5E31238908A-02
137
9.5.4
Messages by LEDs on the module
The LEDs on the front of the SIWAREX module signal the following status and error
messages.
Item
Color
Labeling
Function
Line 1
LED 0
DIAG
System fault
Ready
flashing
Service mode is switched on
LED 1 Limit 1 responded
LED 23 Limit 2 responded
LED 3 Limit 3 responded (empty limit)
LED 4 Standstill status
LED 5
-0-
¼ d zero status
LED 6
Max
Max. violated (with NAW Max+9e)
LED 7 Parameter input blocked (write protection)
LED 8 Not used
LED 19
LC
Load cell(s) OK
Load cell(s) faulty
LED 10 Not used
LED 11 Not used
LED 12 Not used
LED 13 Not used
LED 14 Not used
LED 15 Not used
LED 16
AQ
Analog output active
Analog output faulty
Line 2
LED 1
LINK
LAN connection exists
LED 2
Rx/Tx
LAN communication active
LED 3 Not used