Siemens TC63 - AT+CRLP Select Radio Link Protocol Parameters for Originated Non-Transparent Data Calls

TC63 AT Command Set
7.20 AT+CRLP
s
TC63_ATC_V00.490 Page 163 of 501 5/24/05
Confidential / Draft - Do not copy
7.20 AT+CRLP Select radio link protocol parameters for originated
non-transparent data calls
The AT+CRLP write command sets radio link protocol (RLP) parameters used when non-transparent data calls
are originated. The read command returns the current settings for the supported RLP version 0.
Syntax
Parameter Description
Interworking window size (IWF to MS)
0...61
(&F)
Mobile window size (MS to IWF)
0...61
(&F)
Acknowledgement timer (T1 in 10 ms units)
48...[78]
(&F)
...255
Re-transmission attempts N2
1...6
(&F)
...255
Test Command
AT+CRLP=?
Response(s)
+CRLP: (list of supported<iws>s), (list of supported<mws>s), (list of supported<T1>s), (list of
supported<N2>s)
OK
Read Command
AT+CRLP?
Response(s)
+CRLP: <iws>, <mws>, <T1>, <N2>
OK
Write Command
AT+CRLP=[<iws>[, <mws>[, <T1>[, <N2>]]]]
Response(s)
OK
ERROR
+CME ERROR: <err>
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge 4 Last
GSM 07.07 ! % ! % % ! ! ! % !
<iws>
(num)(&W)(&V)
<mws>
(num)(&W)(&V)
<T1>
(num)(&W)(&V)
<N2>
(num)(&W)(&V)