Siemens TC63 - 10.6 AT^SISW Internet Service Write Data

TC63 AT Command Set
10.6 AT^SISW
s
TC63_ATC_V00.490 Page 263 of 501 5/24/05
Confidential / Draft - Do not copy
10.6 AT^SISW Internet Service Write Data
AT^SISW write command triggers writing data via the Internet service configured configured with AT^SISS.
TC63 returns the amount of data which can be written:
• <cnfWriteLength> value equal 0 indicates that the TC63 failed to enter online data mode. Details about
the cause of failure is available using AT+CEER.
• <cnfWriteLength> value greater than 0 indicates that the TC63 switches into online data mode to transfer
the given number of bytes.
A URC "^SISW: <srvProfileId>, <urcCauseId>" will be issued if
• the TC63 is capable to send data after opening the Internet service or
• less transmission buffer space was confirmed (in <cnfWriteLength>) than requested (with <reqWrite-
Length>) or
• or all available data have been transferred.
This mechanism is designed to avoid polling for free transmission buffer space and thus, free the TA for other
tasks.
Syntax
Unsolicited Result Code
^SISW: <srvProfileId>, <urcCauseId>
Data availability status of the Internet service configured with AT^SISS has changed.
Parameter Description
<srvProfileId> 0 ... 9 specified with AT^SISS.
Requested number of data bytes to be transmitted via the Internet service configured with AT^SISS.
1...1500
Confirmed number of data bytes to be transmitted via the Internet service configured in <srvProfileId>. This
number may be less or equal to the value requested with <reqWriteLength>. 0 value indicates that no data
can be written.
Test Command
AT^SISW=?
Response(s)
OK
Write Command
AT^SISW=<srvProfileId>, <reqWriteLength>
Response(s)
^SISW: <srvProfileId>, <cnfWriteLength>Number of data bytes are expected as specified by
<cnfWriteLength>
OK
ERROR
+CME ERROR: <err>
PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge 4 Last
§ % % % % % % ! ! %
<srvProfileId>
(num)
<reqWriteLength>
(num)
<cnfWriteLength>
(num)