TC63 AT Command Set
4.5 ATE
s
TC63_ATC_V00.490 Page 93 of 501 5/24/05
Confidential / Draft - Do not copy
4.5 ATE Enable command echo
The ATE command determines whether or not the TA echoes characters received from TE during command
state.
Syntax
Parameter Description
[0] Echo mode off
1
(&F)
Echo mode on
Note
• In case of using the command without parameter, <value> is set to 0.
Exec Command
ATE[<value>]
Response(s)
OK
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge 4 Last
V.250 ! % % % % % % ! % !
<value>
(num)(&W)(&V)
To Next Page
Loading...
