Siemens TC63 - AT^SNFV Set Loudspeaker Volume

TC63 AT Command Set
18.17 AT^SNFV
s
TC63_ATC_V00.490 Page 432 of 501 5/24/05
Confidential / Draft - Do not copy
18.17 AT^SNFV Set loudspeaker volume
AT^SNFV can be used to set the volume of the loudspeaker to the value <outCalibrate> addressed by <out-
Step>. The read and write commands refer to the active audio mode. The write command works only in audio
modes 2 to 6.
Syntax
Parameter Description
The actual volume of each step is defined by the parameter <outCalibrate>, which can be set with AT^SNFO.
0...4
(P)
Notes
• Any change to <outStep> takes effect in audio modes 2 to 6. That is, when you change <outStep> and
then select another mode with AT^SNFS, the same step will be applied. Nevertheless, the actual volume can
be quite different, depending on the values of <outCalibrate> set in each mode. The only exception is
audio mode 1 which is fixed to <outStep>=4.
• <outStep> is stored non-volatile when the ME is powered down with AT^SMSO or reset with AT+CFUN=1,1.
<outStep> is not stored by AT^SNFW.
• <outStep> can also be changed by AT^SNFO (Section 18.13) and AT+CLVL (Section 18.4).
Test Command
AT^SNFV=?
Response(s)
^SNFV: (list of supported <outStep>s)
OK
Read Command
AT^SNFV?
Response(s)
^SNFV: <outStep>
OK
Write Command
AT^SNFV=<outStep>
Response(s)
OK
ERROR
+CME ERROR
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge 4 Last
SIEMENS ! % % % % % % ! % !
<outStep>
(num)