TC63 AT Command Set
2.12 AT+CMEE
s
TC63_ATC_V00.490 Page 46 of 501 5/24/05
Confidential / Draft - Do not copy
2.12 AT+CMEE Mobile Equipment Error Message Format
AT+CMEE controls the format of the error result codes that indicates errors related to TC63 functionality. Format
can be selected between plain "ERROR" output, error numbers or verbose "+CME ERROR: <err>" and "+CMS
ERROR: <err>" messages.
Possible error result codes are listed in Table 2.4, General "CME ERROR" Codes (GSM 07.07), Table 2.6,
GPRS related "CME ERROR" Codes (GSM 07.07) and Table 2.8, SMS related "CMS ERROR" Codes (GSM
07.05).
In multiplex mode (refer AT+CMUX) the setting applies only to the logical channel where selected. The setting on
the other channels may differ.
Syntax
Parameter Description
0
(&F)(D)
Disable result code, i.e. only "ERROR" will be displayed.
1 Enable error result code with numeric values.
2 Enable error result code with verbose (string) values.
Example
To obtain enhanced error messages it is recommended to choose <errMode>=2.
Test Command
AT+CMEE=?
Response(s)
+CMEE: (list of supported<errMode>s)
OK
Read Command
AT+CMEE?
Response(s)
+CMEE: <errMode>
OK
Write Command
AT+CMEE=<errMode>
Response(s)
OK
ERROR
+CME ERROR: <err>
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge 4 Last
GSM 07.07 ! % % % % % % ! % !
<errMode>
(num)(&W)(&V)
AT+CMEE=2
OK
To Next Page
Loading...
Need help?
General
