Siemens TC63 - AT^SNFD Set Audio Parameters to Manufacturer Default Values

TC63 AT Command Set
18.10 AT^SNFD
s
TC63_ATC_V00.490 Page 421 of 501 5/24/05
Confidential / Draft - Do not copy
18.10 AT^SNFD Set audio parameters to manufacturer default values
AT^SNFD sets the active audio parameters to manufacturer defined default values.
The restored values are:
AT^SNFA: <atten>
AT^SNFI: <inBbcGain>, <inCalibrate>
AT^SNFO: <outBbcGain>, <outCalibrate>[0 to 4], <sideTone>
AT^SAIC: <io>, <mic>, <ep>
AT^SNFS: <audMode>
Syntax
Note
• Remember that the factory set audio mode 1 is fixed to <outStep>=4. Consequently, AT^SNFD restores
<audMode> together with <outStep>=4, but does not affect the values of <outStep> currently selected in
audio modes 2 - 6. This means, if <audMode>=1, the read commands AT^SNFO, AT^SNFV and AT+CLVL will
always deliver <outStep>=4. In all other modes the <outStep> value is retained until explicitly changed.
Test Command
AT^SNFD=?
Response(s)
OK
Exec Command
AT^SNFD
Response(s)
OK
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge 4 Last
SIEMENS ! % % % % % % ! % !