TC63 AT Command Set
12.6 AT+FTH
s
TC63_ATC_V00.490 Page 316 of 501 5/24/05
Confidential / Draft - Do not copy
12.6 AT+FTH Transmit Data Using HDLC Framing
The AT+FTH command causes the TA to transmit data using HDLC protocol and the modulation mode defined
in Section 12.1, FAX parameters. An ERROR response code results if this command is issued while the modem
is on-hook.
Syntax
Notes
• Used for Fax Class 1 only
•Only <mod>= 3 is possible
Write Command
AT+FTH=<mod>
Response(s)
CONNECT
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge 4 Last
TIA/EIA-578 ! % ! % % ! ! ! ! !
To Next Page
Loading...
