TC63 AT Command Set
18.14 AT^SNFPT
s
TC63_ATC_V00.490 Page 427 of 501 5/24/05
Confidential / Draft - Do not copy
18.14 AT^SNFPT Set progress tones
AT^SNFPT controls the Call Progress Tones generated at the beginning of a mobile originated call setup.
Please note that the setting is stored volatile, i.e. after restart or reset, the default value 1 will be restored.
Syntax
Parameter Description
0 Disables Call Progress Tones
1
(P)
Enables Call Progress Tones (audible tones shortly heard on the phone when
ME starts to set up a call.)
Test Command
AT^SNFPT=?
Response(s)
^SNFPT: (list of supported <pt>s)
OK
Read Command
AT^SNFPT?
Response(s)
^SNFPT: <pt>
OK
Write Command
AT^SNFPT=<pt>
Response(s)
OK
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge 4 Last
SIEMENS ! % % % % % % ! % !
<pt>
(num)
To Next Page
Loading...
