TC63 AT Command Set
20. Miscellaneous Commands
s
TC63_ATC_V00.490 Page 457 of 501 5/24/05
Confidential / Draft - Do not copy
20. Miscellaneous Commands
The AT Commands described in this chapter are related to various areas.
20.1 A/ Repeat previous command line
Syntax
Command Description
Repeat previous command line.
Notes
• Line does not need to end with terminating character.
• After beginning with the character "a" or "A" a second character "t", "T" or "/" has to follow. In case of using a
wrong second character, it is necessary to start again with character "a" or "A".
• If autobauding is active, the command A/ cannot be used (see AT+IPR).
Exec Command
A/
Response(s)
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge 4 Last
V.250 ! % % % % % % ! % !
To Next Page
Loading...
