TC63 AT Command Set
13.8 AT+CMGW
s
TC63_ATC_V00.490 Page 333 of 501 5/24/05
Confidential / Draft - Do not copy
13.8 AT+CMGW Write SMS messages to memory
Syntax
Command Description
The execute and write commands transmit SMS (either SMS-DELIVER or SMS-SUBMIT) from TE to memory
storage <mem2>. Memory location <index> of the stored message is returned. Message status will be set to
'stored unsent' unless otherwise given in parameter <stat>.
After invoking the execute or write command wait for the prompt ">" and then start to write the message. To save
the message simply enter
<CTRL-Z>. After the prompt a timer will be started to observe the input.
To abort writing use
<ESC>. Abortion is acknowledged with "OK", though the message will not be saved.
Notes
• If writing fails, for example, if a message is too long, the result code depends on the current setting of the
AT^SM20 command:
If the AT^SM20 <CmgwMode>=1 (factory default) any failure to send a message is responded with "OK". Users
should be aware, that despite the "OK" response, the message will not be written to the selected SMS stor-
age.
If the AT^SM20 <CmgwMode> equals 0 any failure to write a message is responded with "ERROR".
Test Command
AT+CMGW=?
Response(s)
OK
Exec Command
If text mode (see AT+CMGF=1):
AT+CMGW
Response(s)
<CR> Text can be entered. <CTRL-Z>/<ESC>
+CMGW: <index>
OK
If writing fails
ERROR
+CMS ERROR
Write Command
If text mode (see AT+CMGF=1):
AT+CMGW=<oa>/<da>[, [<tooa>/<toda>][, <stat>]]
<CR> Text can be entered. <CTRL-Z>/<ESC>
Response(s)
+CMGW: <index>
OK
If writing fails see notes below.
Write Command
If PDU mode (see AT+CMGF=0):
AT+CMGW=<length>[, <stat>]
<CR> PDU can be entered. <CTRL-Z>/<ESC>
Response(s)
+CMGW: <index>
OK
If writing fails see notes below.
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge 4 Last
GSM 07.05 % % % % % % % ! % !
To Next Page
Loading...
