Siemens TC63 - AT Command Settings Storable with AT&W; Table 21.7: Settings Stored to User Profile on ASC0; MUX Channel 1

TC63 AT Command Set
21.5 AT Command Settings storable with AT&W
s
TC63_ATC_V00.490 Page 480 of 501 5/24/05
Confidential / Draft - Do not copy
21.5 AT Command Settings storable with AT&W
Table 21.7: Settings Stored to User Profile on ASC0 / MUX Channel 1
AT Command Stored Parameters
Configuration Commands
ATQ <n>
ATV <value>
ATX <value>
AT\V <value>
AT+CMEE <errMode>
Status Control Commands
ATS18 <n>
Serial Interface Control Commands
AT\Q <n>
AT&C <value>
AT&D <value>
AT&S <value>
ATE <value>
AT+ICF <format>, <parity>
AT+IFC <TEflowcontrol>, <TAflowcontrol>
AT+ILRR <value>
AT^STPB <n>
Call related Commands
ATS0 <n>
ATS6 <n>
ATS7 <n>
ATS8 <n>
ATS10 <n>
AT+CBST <speed>, <name>, <ce>
AT+CRLP <iws>, <mws>, <T1>, <N2>
AT^SLCC <n>
AT+CR <mode>
AT+CRC <mode>
Network Service Commands
AT+COPS <format>
AT+CREG <n>
Supplementary Service Commands
AT^SACM <n>