Siemens TC63 - ATL Set Monitor Speaker Loudness; ATM Set Monitor Speaker Mode

TC63 AT Command Set
18.2 ATL
s
TC63_ATC_V00.490 Page 412 of 501 5/24/05
Confidential / Draft - Do not copy
18.2 ATL Set monitor speaker loudness
ATL is implemented for V.250ter compatibility reasons only, and has no effect. In multiplex mode (refer
AT+CMUX) the command is supported on logical channel 1 only.
Syntax
Parameter Description
18.3 ATM Set monitor speaker mode
ATM is implemented for V.250ter compatibility reasons only, and has no effect. In multiplex mode (refer
AT+CMUX) the command is supported on logical channel 1 only.
Syntax
Parameter Description
Exec Command
ATL[<val>]
Response(s)
OK
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge 4 Last
V.250 ! % ! ! % ! ! ! % !
<val>
(num)
Exec Command
ATM[<val>]
Response(s)
OK
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge 4 Last
V.250 ! % ! ! % ! ! ! % !
<val>
(num)