Siemens TC63 - SAP Response Message Parameter

TC63 AT Command Set
15.2 AT^SRSM
s
TC63_ATC_V00.490 Page 383 of 501 5/24/05
Confidential / Draft - Do not copy
15.2.2 SAP Response Message Parameter
The following table shows all SAP response and indication message parameters that are used in two cases:
• An URC "^SRSM" is issued by an ME acting as SAP server, then
•an AT^SRSM write command transfers its data into an ME acting as SAP client.
SAP Response Message Parameter Mapping:
Id SAP Message Name SAP parameter mapping to AT^SRSA parame-
ters
<RsaMsgId> [,<RsaMsgData> [,<RsaMs-
gLen> [,<RsaMsgRc>]]]
0 CONNECT_REQ 0,,<MaxMsgSize>
2 DISCONNECT_REQ 2
5 TRANSFER_APDU_REQ 5,<CmdApdu>,<CmdApduLen>
7 TRANSFER_ATR_REQ 7
9 POWER_SIM_OFF_REQ 9
11 POWER_SIM_ON_REQ 11
13 RESET_SIM_REQ 13
15 TRANSFER_CARD_READER _STATUS_REQ 15
Id SAP Message Name SAP parameter mapping to AT^SRSA parame-
ters
<RsaMsgId> [,<RsaMsgData> [,<RsaMs-
gLen> [,<RsaMsgRc>]]]
1 CONNECT_RESP 1,,<MaxMsgSize>,<ConnStatus>
3 DISCONNECT_RESP 3
4 DISCONNECT_IND 4,,,<DiscType>
6 TRANSFER_APDU_RESP 6,<RspApdu>,<RspApduLen>,<ResCode>
8 TRANSFER_ATR_RESP 8,<ATR>,<AtrLen>,<ResCode>
10 POWER_SIM_OFF_RESP 10,,,<ResCode>
12 POWER_SIM_ON_RESP 12,,,<ResCode>
14 RESET_SIM_RESP 14,,,<ResCode>
16 TRANSFER_CARD_READER
_STATUS_RESP
16,,<CardRdStatus>,<ResCode>
17 STATUS_IND 17,,,<StatusChange>
18 ERROR_RESP 18