Siemens TC63 - AT+CNMI New SMS Message Indications

TC63 AT Command Set
13.11 AT+CNMI
s
TC63_ATC_V00.490 Page 337 of 501 5/24/05
Confidential / Draft - Do not copy
13.11 AT+CNMI New SMS message indications
Syntax
Unsolicited Result Codes
URC 1
<mt>=1:
+CMTI: <mem3>, <index>
Indicates that new message has been received
URC 2
<mt>=2 (PDU mode enabled):
+CMT: <length>
<CR><LF><pdu>
Indicates that new message has been received
URC 3
<mt>=2 (text mode enabled):
+CMT: <oa>, <scts>[, <tooa>, <fo>, <pid>, <dcs>, <sca>, <tosca>,
<length>]
<CR><LF><data>
Indicates that new message has been received
URC 4
<bm>=2 (PDU mode enabled):
+CBM: <length>
<CR><LF><pdu>
Indicates that new cell broadcast message has been received
Test Command
AT+CNMI=?
Response(s)
+CNMI: (list of supported<mode>s), (list of supported <mt>s), (list of supported <bm>s), (list of supported
<ds>s), (list of supported <bfr>s)
OK
Read Command
AT+CNMI?
Response(s)
+CNMI: <mode>, <mt>, <bm>, <ds>, <bfr>
OK
Write Command
AT+CNMI=[<mode>][, <mt>][, <bm>][, <ds>][, <bfr>]
Response(s)
OK
ERROR
+CMS ERROR
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge 4 Last
GSM 07.05 % % % % % % % ! % !