Siemens TC63 - Page 238

TC63 AT Command Set
10.1 AT^SICS
s
TC63_ATC_V00.490 Page 238 of 501 5/24/05
Confidential / Draft - Do not copy
Parameter Description
Internet connection profile identifier.
The <conProfileId> identifies all parameters of a connection profile, and, when a service profile is created
with AT^SISS the <conProfileId> needs to be set as "conId" value of the AT^SISS parameter <srv-
ParmTag>.
0...5
Internet connection parameter.
“conType“ Type of Internet connection.
For supported values of <conParmValue> refer to <conParmValue-con-
Type>.
“alphabet“ Selects the character set for input and output of string parameters within a pro-
file.
The selected value is bound to the specific profile. This means that different
profiles may use different alphabets. Unlike other parameters the alphabet can
be changed no matter whether the <conParmTag> value "conType" has been
set.
For supported values of <conParmValue> refer to <conParmValue-
alphabet>.
“user“ User name string: maximum 32 characters (where "" is default).
“passwd“ Password string: maximum 32 characters (where "" is default).
If <conParmValue-authMode> is "MsChapV1" then the maximum password
length is 16 characters.
“apn“ Access point name string value: maximum 100 characters (where "" is default).
“inactTO“ Inactivity timeout value in seconds: 0
Changing the value is not allowed (if changed the value will be reset to 0).
“calledNum“ Called BCD number.
“dataRate“ Data rate.
For supported values of <conParmValue> refer to <conParmValue-dat-
aRate>.
“dataType“ Data call type.
For supported values of <conParmValue> refer to <conParmValue-
dataType>.
“authMode“ Authentication mode.
For supported values of <conParmValue> refer to <conParmValue-auth-
Mode>.
“dns1“ Primary DNS server address (IP address in dotted-four-byte format).
This value determines whether to use the DNS server addresses dynamically
assigned by the network or a specific DNS server address given by the user.
"dns1" = "0.0.0.0" (default) means that the CSD or GPRS connection profile
ERROR
+CME ERROR: <err>
PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge 4 Last
! % % % % % % ! % !
<conProfileId>
(num)
<conParmTag>
(str)
Write Command (Continued)
AT^SICS=<conProfileId>, <conParmTag>, <conParmValue>
Response(s)