TC63 AT Command Set
11.2 AT+CGANS
s
TC63_ATC_V00.490 Page 271 of 501 5/24/05
Confidential / Draft - Do not copy
If no <cid> is given or if there is no matching context definition, the MT will attempt to activate the context
using the values for PDP type and address provided by the network. The other parameters will be set to their
default values (see AT+CGDCONT).
If activation is successful, data transfer may proceed.
After data transfer is complete, and the layer 2 protocol termination procedure has completed successfully,
the V.250 command state is reentered and the MT returns the final result code OK.
In the event of an erroneous termination or a failure to start up, the V.250 command state is re-entered and
the MT returns the final result code NO CARRIER, or if enabled, +CME ERROR. Attach, activate and other
errors may be reported. It is also an error to issue the AT+CGANS command when there is no pending network
request.
The command may be used in both normal and modem compatibility modes.
To Next Page
Loading...
