Siemens TC63 - Page 439

TC63 AT Command Set
19.2 AT+CALA
s
TC63_ATC_V00.490 Page 439 of 501 5/24/05
Confidential / Draft - Do not copy
• Alarm settings on ASC0 / ASC1 and different Multiplexer channels (see AT+CMUX):
- On each interface an individual <text> message can be stored, but only one time setting applies. This
means an alarm <time> set on one of the interfaces overwrites the time setting on all remaining inter-
faces. Therefore, the total number of alarm events returned by the read command AT+CALA? will always
be <n>=0, no matter whether different text messages are stored.
- When the scheduled alarm occurs, the ME sends the URC only on the interface where the most recent
alarm setting was made. The alarm time will be reset to "00/01/01,00:00:00" on all interfaces.
Examples
EXAMPLE 1
You may want to configure a reminder message for July 31, 2005, at 9.30h, including the message "Good
Morning".
Do not switch off the GSM engine.When the alarm occurs the ME returns the following URC:
EXAMPLE 2
To set a fresh alarm using the same message as in Example 1, simply enter date and time. <n>, <type>,
<text>, <tlength> can be omitted:
When the alarm is executed the URC comes with the same message:
EXAMPLE 3
To enable the ME to wake up into Airplane mode, e.g. on July 20, 2005, at 8.30h, enter
Next, power down the ME:
When the alarm is executed the ME wakes up to Airplane mode and displays a URC. If available, this line is
followed by the individual <text> most recently saved. If no individual message was saved only the first line
appears.
EXAMPLE 4
To delete an alarm before its scheduled time is reached enter an empty string for parameter <time>. This
will restore the default time and clear any individual message defined with <text>.
AT+CALA="05/07/31,09:30:00",0,0,"Good Morning"
OK
+CALA: Good Morning
AT+CALA="05/07/31,08:50:00"
OK
+CALA: Good Morning
AT+CALA="05/07/20,08:30:00"
OK
AT^SMSO
^SMSO: MS OFF
OK
^SHUTDOWN
" ^SYSSTART AIRPLANE MODE "
+CALA: Good Morning
AT+CALA=""
OK
AT+CALA?
+CALA: "00/01/01,00:00:00",0,0,""
OK