Siemens TC63 - Page 72

TC63 AT Command Set
3.3 AT^SIND
s
TC63_ATC_V00.490 Page 72 of 501 5/24/05
Confidential / Draft - Do not copy
Unsolicited Result Codes
URC 1
Format of the standard indicator:
+CIEV: <indDescr>, <indValue>
Value related to an indicator has changed.
URC 2
Format of the "adnread" indicator issued when accessing the ADN phonebook records stored on the SIM:
+CIEV: <indDescr>, <adnEntry>, <adnNumber>, <adnType>, <adnText>
+CIEV: <indDescr>, "READY"
One URC is issued for every used Abbreviated Dialing Number (ADN) phonebook record. After the last record
of the ADN phonebook was read, a URC with "READY" tag signals end of processing.
URC 3
Format of the Voice Message indicator, if the number of waiting messages is delivered by the network:
+CIEV: <indDescr>, <indValue>, <vmCounter>
If the number of waiting messages is not delivered the standard indicator applies.
URC 4
Format of the "eons" indicator:
+CIEV: <indDescr>, <indValue>, <eonsOperator>, <servProvider>
One URC is issued for each new LAI (Location Area Information) broadcast by the network.
URC 5
Format of the "nitz" indicator:
+CIEV: <indDescr>, <nitzUT>, <nitzTZ>, <nitzDST>
Parameter Description
String values and their <indValue> ranges.
All indicators supported by AT+CIND are accessible with this command, too. A detailed description of these indi-
cators can be found there.
The following indicators are accessible via AT^SIND only:
“audio“ Activity of the built-in audio unit.
“vmwait1“ Voice Message Waiting Indication for line 1
"vmwait1" and "vmwait2" indicate the receipt of a special short message with
a Voice Message Waiting Indicator. The service must be provisioned by the
operator.
The numbers 1 or 2 in "vmwait1" and "vmwait2" are related to the two lines of
the Alternate Line Service (ALS), also defined in CPHS Phase 2 standard. For
further details refer to the AT^SALS command.
The presentation mode of the indicator varies with the operator: If more than
one message are waiting, some operators only indicate the first one, others
deliver the indicator each time a new voice message is put into the mailbox.
<indDescr>
(str)
0 Audio unit not active.
1 Value 1 means for example:
Outgoing voice call: Indicator appears when dialing starts.
Incoming voice call: Indicator appears prior to the RING result code.
0 The value 0 notifies that no new voice message is available, and is pro-
vided by the service center to clear the voice message indication after
the subscriber has retrieved all voice messages.
1 The value 1 notifies the subscriber that the mailbox contains one or
several messages.