Section 08 BODY / FRAME
Sub-Section 02 (BODY)
08-02-3
PLASTIC MAINTENANCE AND REPAIR
MAINTENANCE
Clean the vehicle thoroughly, removing all dirt and
grease accumulation.
To clean use a soft clean cloth and either soapy
water or isopropyl alcohol.
To remove grease, oil or glue use isopropyl alco-
hol.
CAUTION : Do not apply isopropyl alco-
hol or acetone directly on decals.
CAUTION : The following products
must
not
be used to clean or wax any of the
plastic components used on the vehicles :
– gasoline
– brake fluid
– kerosene
– diesel fuel
– lighter fluid
– varsol
–naphtha
– acetone
– strong detergents
– abrasive cleaners
– waxes containing an abrasive or a cleaning
agent in their formula
CAUTION : Clean R.I.M. Metton
®
with iso-
propyl alcohol
only
.
Never
use cleaners
or products containing
chlorine
.
Apply wax on glossy finish only. Protect the vehi-
cle with a cover to prevent dust accumulation dur-
ing storage.
CAUTION : If for some reason the snow-
mobile has to be stored outside it is pref-
erable to cover it with an opaque tarpaulin.
This will prevent the sun rays from affecting
the plastic components and the vehicle finish.
REPAIR
The very first step before repairing plastic materi-
als is to find out exactly which type of material is
involved. Refer to following chart.
CAUTION : Consult chart and repair kit in-
structions carefully, some repair products
are not compatible with certain plastics.
WARNING : Polycarbonate windshields
must
never
be repaired by welding or
otherwise.
;
PART MODEL
REPAIRABLE IRREPARABLE
R.I.M. POLYURETHANE POLYETHYLENE
HOOD
A03H0ZJ
Tundra II LT
S-Series
BOTTOM PAN
Tundra II LT
S-Series
A06H1AJ
To Next Page
Loading...
Need help?
General
