Section 03 ENGINE
Sub-Section 03 (377, 443 AND 503 ENGINE TYPES)
03-03-3
ENGINE REMOVAL AND
INSTALLATION
Disconnect or remove the following :
WARNING : Before disconnecting any
electrical wire in starter system always
first disconnect the BLACK negative battery ca-
ble (on electric starting models).
– negative cable from battery (on electric starting
models)
– belt guard
– drive belt
– drive pulley using appropriate puller, refer to 04-03
DRIVE PULLEY
– air silencer and carburetors
– impulse line from engine crankcase
– 4-connector housing
– exhaust pipe and exhaust cooling hose on so
equipped models
– oil pump inlet tube and plug it
– oil pump cable
TUNED PIPE IDENTIFICATION
This part is identified on welded support.
Second number sequence of P / N is stamped on
part.
1. Identification : 0467 for 514 0467 00
A03C1KA
1
To Next Page
Loading...
