Section 04 TRANSMISSION
Sub-Section 06 (BRAKE)
04-06-4
INSTALLATION
To install brake, reverse removal procedure paying
attention to the following.
7, Brake Pad
After brake pads installation, brake disc must be
centered in caliper. Apply brake then check for
proper brake disc positioning.
Push on appropriate caliper piston in order to
move pad inward allowing proper brake disc posi-
tioning.
1. Brake disc not centered
2. Brake disc centered
3. Apply brake before checking
Apply brake then recheck.
17, Brake Disc
Apply anti-seize lubricant (P/N 413 7010 00) on
shaft.
The disc hub exceeds the disc more from one
side than from the other. Install disc with the long-
er exceeding portion toward driven pulley.
ADJUSTMENT
Countershaft Bearing
Insert countershaft (with brake disc) from chain-
case side through countershaft support (driven
pulley side), then insert into chaincase.
Install countershaft bearing
no. 19
and ensure
that countershaft is properly aligned, then tighten
3 retaining screws.
NOTE:
A misaligned countershaft will result in dif-
ficulty to center the bearing in its support.
Refer to DRIVE AXLE 06-03 then look
Chaincase
Perpendicularity Adjustment.
Torque castellated nut of upper sprocket to 53
N•m (39 lbf•ft).
◆
WARNING
Avoid getting oil on brake pads.
TITE
CK
X
A06D15A
-
CAUTION
Upper sprocket castellated nut must be
tightened
before
adjusting bearing collar.
1
A03D2KA
2
3
To Next Page
Loading...
