CONTROLS
11. UP ARROW (): Use this key to increase the numeric values in the setup mode.
This key is also used to toggle ON/OFF functions. Also may be used to increase
output voltage during a test in 10-volt increments.
12. EXIT KEY: Use this key when you desire to enter the test mode to initiate a test.
Also the key uses to enter the System menu parameters and to exit from the System
menu.
13. HIGH VOLTAGE OUTPUT TERMINAL: For the connection of the detachable
6-foot (1.8 m) red high voltage test lead. The silicone rubber insulation is flexible
for easy handling and is rated at 30KVDC. The terminal is recessed for safety when
this lead is not being used.
14. HIGH VOLTAGE ARROW (LED INDICATOR): This indicator flashes to warn
the operator that high voltage is present at the high voltage output terminal.
15. RETURN OUTPUT TERMINAL: For the connection of the detachable 5 foot
(1.52 m) black return test lead. This terminal is always used when performing a test.
To Next Page
Loading...
