CONTROLS
9. GND CONNECTION: This terminal is wired in parallel with the Current Output
terminal during a Ground Bond test and may be used in place of the front panel
connection. During a Line Leakage test this connection provides a connection to one
side of the measuring device (MD). Please refer to the Instrument Connections
section for details on connecting the instrument and the device under test.
10. CASE CONNECTION: This terminal is wired in parallel with the Return terminal
during a Ground Bond test and may be used in place of the front panel connection.
During a Line Leakage test this connection provides a connection to one side of the
measuring device (MD). During ACW, DCW or IR testing this terminal provides
the return connection. Please refer to the Instrument Connections section for
details on connecting the instrument and the device under test.
11. CHASSIS GROUND (EARTH) TERMINAL: This safety terminal should be
connected to a good earth ground before operation.
12. INPUT POWER RECEPTACLE: Standard IEC 320 connector for connection to a
standard NEMA style line power (mains) cord.
13. VOLTAGE SELECT SWITCH: Line voltage selection is set by the position of
the switch. In the left position, it is set for 115-volt operation, in the right position it
is set for 230-volt operation.
14. THERMAL FAN: To cool the instrument.
To Next Page
Loading...
