OPERATION
Press the Up () or Down () arrow keys to toggle the frequency setting to 50 or 60
Hertz, then press the SET key to advance to the next parameter or press the EXIT key to
store the frequency setting and return to the test mode.
7.6. To set the Connect mode ON/OFF
Press the SET key until the display shows:
Press the Up () or Down () arrow keys to toggle the connect mode to ON or OFF, then
press the SET key to advance to the next parameter or press the EXIT key to store the
setting and return to the test mode. If Connect is set to ON the next step in the sequence
will be executed. If Connect is set to OFF the test sequence will stop at this step. If step
10 is set to ON the test process will be connected to the first step of the next memory.
Step 10 of the memory 20 does not have Connect ON/OFF option.
8. Functional Run test mode setting
8.1. To set the HI and LO Limits (Voltage)
Press the SET key until the display shows:
Use the Up () or Down () arrow keys to enter the desired value of the High or Low
Limits voltage trip point then press the SET key to advance to the next parameter or press
the EXIT key to store the setting and return to the test mode. The unit of measure is 0 –
277 VAC. Any attempt to set the value outside these limits will cause the instrument to
indicate an ERROR by producing two short beeps.
8.2. To set the HI and LO Limits (Current)
Press the SET key until the display shows:
Use the Up () or Down () arrow keys to enter the desired value of the High or Low
Limits resistance trip point then press the SET key to advance to the next parameter or
press the EXIT key to store the setting and return to the test mode. The unit of measure is
0 – 30 amps. Any attempt to set the value outside these limits will cause the instrument to
indicate and ERROR by producing two short beeps.
8.3. To set the HI and LO Limits (Power)
Press the SET key until the display shows:
To Next Page
Loading...
