Slaughter 6330 - Power Cable; Operating Environment; Storage and Shipment

INSTALLATION
27
Power Cable
BEFORE CONNECTING POWER TO THIS
INSTRUMENT, THE PROTECTIVE GROUND (EARTH)
TERMINALS OF THIS INSTRUMENT MUST BE
CONNECTED TO THE PROTECTIVE CONDUCTOR OF THE LINE (MAINS)
POWER CORD. THE MAIN PLUG SHALL ONLY BE INSERTED IN A
SOCKET OUTLET (RECEPTACLE) PROVIDED WITH A PROTECTIVE
GROUND (EARTH) CONTACT. THIS PROTECTIVE GROUND (EARTH)
MUST NOT BE DEFEATED BY THE USE OF AN EXTENSION CORD (POWER
CABLE) WITHOUT A PROTECTIVE CONDUCTOR (GROUNDING).
This instrument is shipped with a three-wire power cable. When this cable is connected
to an appropriate AC power source, this cable connects the chassis to earth ground. The
type of power cable shipped with each instruments depends on the country of destination.
Operating Environment
This equipment is intended for indoor use only. The equipment has been evaluated
according to Installation Category II and Pollution Degree 2 as specified in IEC 664.
This instrument may be operated within the following environmental conditions:
Temperature………….41° - 104° F (5° - 40° C)
Relative humidity …….0 - 80%
Altitude ………………6,560 feet (2,000 meters)
Do not block any ventilation openings to prevent over heating of
the equipment. Keep the ventilation slits uncovered during
operation. Failure to do so could cause the instrument to overheat
and may damage internal components.
If the instrument is used in a matter not specified by the manufacturer, the protection
provided by the instrument may be impaired.
STORAGE AND SHIPMENT
Environment
This instrument may be stored or shipped in environments with the following limits:
Temperature.................-40° - 167° F (-40° - 75°C)
Altitude............................ 50,000 feet (15,240 meters)
The instrument should also be protected against temperature extremes which may cause
condensation within the instrument.
Field Installation of Options
There are no field installable options on the model 6330.