SLE SLE5000 Model J - Page 206

Page 206 (Model J)
24.2.4 Controls
Reset button: Resets current alarm
Reset contamination alarm button: Resets the alarm
Return button: Returns to previous panel
Select button: Tabs between time and date values
Set BPM button: Selects BPM against time display
Set time and date button: Activates time and date panel
Set Trigger button Activates breath detection trigger threshold
SIMV button: Selects SIMV mode
Standby button: Sets ventilator into 90 second standby mode
Stored loop button Displays stored loops
Ti parameter: control: 0.1 to 3 seconds (Resolution 0.01 seconds)
Tidal vol parameter: control: 2 to 200 ml
From 2ml to 6ml the parameter increments in 0.2ml steps (Fine resolution).
From 6ml to 100ml the parameter increments in 1ml steps (Standard resolution).
From 100ml to 200ml the parameter increments in 5ml steps (Coarse resolution).
TTV button: Selects TTV on/off panel
Two point O
2
calibration button: Activates calibrates O
2
system
Ventilation Off button: Selects ventilation off mode
Version button: Activates version information panel
Vmin Selects minute volume against time display
V/P button: Selects volume versus pressure loop display
Vte button: Selects tidal volume against time display
Waveform display sync button: Toggles waveform display synchronization
Waveshaping button: Activates change wave shape panel
Zero button: Zeros seconds
Zoom in button Zooms in on a trend display
Zoom out button Zooms out of a trend display
ON/OFF: Control for mains power supply