SLE SLE5000 Model J - 4 Equipment List

Page 22 (Model J)
4. Equipment list
To service the SLE5000 infant ventilator the service personnel will require the following
equipment. Items marked with an SLE part number can be obtained by contacting the
service department.
• Electronic engineers tool kit.
•
a/b
Calibration analyser (calibrated in mbar) .......SLE Part Nº: N2830
•
a
Patient circuit....................................................SLE Part Nº: BC5188/100 or /400
•
a
Humidification chamber (Typically MR225) ......SLE Part Nº: N3220
•
b
Test lung...........................................................SLE Part Nº: N6647
•
c
Foam support pad
•
a
Digital Multimeter (1mv resolution)
•
a
Calibration kit....................................................SLE Part Nº: N9025
Which contains the following:
Block and leak Y piece assembly Qty 1
Flow tubing assembly ................ Qty 1
Internal pressure tubing kit ........ Qty 1
Y piece Kit .................................. Qty 1
Dummy load kit .......................... Qty 1
Tygon tubing 3/8" x 9/16" ........... Qty 600mm
•
c
Static protection wrist band
•
c
Anti-static protective bags (300mm x 300mm)
•
a
Flow sensor cable.............................................SLE Part Nº: N6635
•
a
Flow sensor ......................................................SLE Part Nº: N5201
•
a
Exhalation block ...............................................SLE Part Nº: N6622
•
a
Oxygen supply
•
a
Air supply
•
a
Earthing strap
a
Note all items marked with an ‘a’ are required for servicing and overhaul. Without these
items the user will be unable to service or overhaul the SLE5000 ventilator.
b
Note items marked with a ‘b’ are required to carry out the functional testing routine.