SLE SLE5000 Model J - Outputs

(Model J) Page 211
24.7 Outputs
Analogue: None
Digital Input/Outputs: Serial Port, IBM-AT-compatible serial port, 9-pin DSub,
RS-232C
Available parameters:
Set BPM,
Set CPAP level
Set Tidal Volume
Set Insp Time
Set PIP
Set FIO
2
Set HFO Delta P
Set HFO Mean
Set HFO Rate
Ventilation Mode
TTV Status
Set Termination Sensitivity
Set Breath Trigger level
Set Breath Trigger threshold
Set Waveshape value
Set Patient Leak alarm value
Set Apnoea alarm value
Set Low Pressure alarm threshold
Set Cycle Fail alarm threshold
Set High Pressure alarm threshold
Set Low Tidal Volume alarm threshold
Set Low Minute Volume alarm threshold
Set High Minute Volume alarm threshold
Measured Total BPM
Measured CPAP
Measured Insp Time
Measured Insp Volume
Measured Exp Volume
Measured PEEP
Measured PIP
Measured FIO
2
Measured HFO Delta P
Measured HFO Mean
Trigger Count
Measured Minute Volume
Measured Leak
Measure Resistance
Measured Compliance
Measured C20/C
Current Alarm ID
For more details refer to the RS232 addendum. Contact SLE for more details.
Compatability with: Vuelink. Contact SLE for more details.