Need help?Do you have a question about the Somat eDAQlite and is the answer not in the manual?
General| Brand | Somat |
|---|---|
| Model | eDAQlite |
| Category | Data Loggers |
| Language | English |
Covers supply connection, device protection, network design, and signal integrity precautions.
Defines the intended use of eDAQlite and emphasizes project planning and risk analysis for safety.
Highlights risks associated with inappropriate use and untrained personnel.
Details the process of installing TCE software and setting up the eDAQlite hardware.
Outlines the phases involved in conducting a test using the eDAQlite system.
Details Ethernet and serial communication methods and changing IP/host name settings.
Discusses input voltage, battery power, remote power, power save mode, and vehicle power.
Explains data formats (SIE/SIF) and storage options like RAM disk and CompactFlash.
Covers setup for hardwired and wireless network configurations for multiple systems.
Describes the TCE interface, including setup windows, menus, toolbar, and status bar for test configuration.
Details various preferences for communications, general settings, FCS specific, and display options.
Covers defining a test, adding nodes, configuring hardware, and creating channels/DataModes.
Details calibration process, modes, control, and specifications for various input channels.
Explains how to initialize, prerun, start, stop, and end test runs, including interactive triggers.
Details how to control test runs remotely using digital I/O lines.
Covers network setup, synchronization, and remote control for networked systems.
Defines common parameters like ID, Connector, Description, Type, Units, Sample Rate, and Full-Scale Values.
Explains arithmetic and logical computed channels like Desk Calculator, Engineering Scaler, etc.
Covers Interactive Trigger, Trigger Generator, Timed Trigger, and Bitmap Trigger for controlling operations.
Details Time History, Burst History, Event Slice, Message Logger, Peak Valley, and Peak Valley Slice DataModes.
Outlines steps for resolving problems, documenting issues, and using error reporting tools.
Lists common problems like data loss after power cycling and corrupt PC Card file systems.
Explains status and error flags indicating abnormal conditions or system errors.
Provides guidance on recovering data from corrupt SIF files, applicable only to SIF format.
Offers suggestions to avoid DeviceOverFlow or QueueOverFlow errors by optimizing test setup.
Describes Butterworth and linear-phase FIR digital filters for analog input channels.
To Next Page