Somat eDAQlite - Extracting Data from SIE or SIF Files

I2773-4.4 en
83
Somat eDAQ lite
lost to the eDAQ lite temporarily or Ethernet connections broken temporarily. If
necessary, abort the communications loop using the Abort option in the upload
progress window.
NOTE
To increase data analysis performance, chain frame demultiplexing to the upload
process using TCE General Preferences.
4.6.3 Extracting Data from SIE or SIF Files
SIE an SIF files contain more information than what is available when viewing
uploaded data. To access this information, select Open SIE or SIF File from the File
menu.
NOTE
When opening a SIF file, TCE checks the file for any frame multiplexed data records.
If they are present, TCE presents the option to demultiplex all frame multiplexed data
records. Analysis routines that run on a channel by channel basis typically execute
significantly faster using fully demultiplexed data records.
Select one of the following options to access additional test and eDAQ lite information.
Keyword Extraction Options
The keyword extraction options provide the opportunity to extract some of the global
keyword data sets that are embedded in the SIE or SIF data file. To access an
available option, select the corresponding radio button and click OK.
Keyword Data Set Description
TCE Setup File Extract the TCE setup file to a PC file.
FCS Log File Extract the eDAQ lite log file to a PC file.
Test Run Descriptions Extract the TCE test run descriptions to a PC file.
State Mapper File Extract the specified (by index) State Mapper ASCII definition
file to a PC file. The file index starts from 1. TCE appends the
original source ASCII file name to the extracted file. Delete this
file name from the extracted file to reuse the ASCII file in a
State Mapper computed channel (see “State Mapper” on
page 138).
HBM: public