Sony DNW-A75 - Tape Running System and Tape Cleaner Cleaning

5-10
DNW-A75/A75P
5-2-6. Tape Running System and Tape Cleaner Cleaning
w
Keep bare hands away from the sharp edge of the tape cleaner to avoid cuts and
injuries.
Pay careful attention when cleaning the tape cleaner.
Tools
. Cleaning cloth: 3-184-527-01
. Cleaning fluid: 9-919-573-01
Procedure
1. Wipe off the surfaces of the tape cleaner using a paper (such as a sheet of paper
of this manual) to remove the magnetic powder adhered on the tape cleaner.
w
Do not contact the edge portion of the tape cleaner with bare hands.
n
Do not apply an excessive force to the tape cleaner to avoid damaging it.
2. Clean the tape-running surfaces (shaded portions in the figure) of each guide
and the tape cleaner using cleaning cloth moistened with a cleaning fluid.
3. After cleaning, clean them using a dry cleaning cloth two or three times.
5-2. Cleaning
Tape-running System and Tape Cleaner Cleaning
(Threading end mode)
TG-0
TG-5
TG-6
TG-1
(S-TEN)
TG-7
TG-8 (T-TEN)
TG-9
TG-10
TG-4
TG-2
(Entrance guide)
Tape cleaner
Pinch roller
Capstan
TG-3 (Exit guide)
Slant guide