Sony DNW-A75 - F-Series Items

2-30
DNW-A75/A75P
2-17. Setup Menu (F-Series)
2-17-2. F-Series Items
The F-series items contain the following items.
In the “Settings” columm of the table, the factory default settings are indicated by an enclosing box.
No. ITEM Settings Description
F01 AUDIO NR IN SP [ON] Turns on and off the Dolby NR when using a metal tape.
MODE SW ON: Dolby NR is turned on usually
SW: Dolby NR switch is turned on and off depending on the setting of the sub
control panel
m
. This item is used exclusively for analog Betacam longitudinal audio playback
adjustment for 625/50 system.
After adjustment is completed, return to the factory setting “ON”.
. When using an oxide tape, follows the sub control panel switch setting
regardless of the above setting.
F02 EMERGENCY TAPE [ENA] Selects whether emergency tape protection operation is enabled or not when VTR
PROTECTION DIS detects error in tape transport mechanism.
ENA:Tape protection operation is enabled
DIS: Tape protection operation is disabled
n
This item is used exclusively for servo and mechanical adjustment.
After adjustment is completed, return to the factory setting “ENA”.
F13 TRACKING [OFF] Turns on and off the tracking control operation with search dial.
CONTROL VIA ON OFF: Tracking control with the search dial is not activated
SEARCH DIAL ON: Tracking control becomes active when turning the search dial in PLAY mode
n
This item is used exclusively for video tracking adjustment.
After adjustment is completed, return to the factory setting “OFF”.
F16 DEVICE TYPE [0] Determines response data to 9-pin remote command DEVICE TYPE REQUEST
MODIFY:0H 1 (00h, 11h).
| 0: Returns the original device type data of the unit
FFFF Except 0: Returns the set values as they are:
The higher-order two digits are for DATA-1
The lower-order two digits are for DATA-2
n
Any selection of the above does not influence the whole VTR operation including
TTP.
If this item is set to values other than the factory setting “0”, the operation of the
unit is not ensured under the 9-pin remote command control.
F21 PROCESS CONT VR [ON]* Selects whether Process control (step menus, knobs, and switches) is enabled or
LOCAL ENABLE OFF not, when LOCAL DISABLE command is received through the 9-pin remote
connector or the setup menu ITEM-006: LOCAL FUNCTION ENABLE is set to
“DIS” (all disable).
ON: Settings of above Process control are enabled
OFF:Settings of above Process control are disabled
n
*: When the SY1 ROM version is earlier than 1.33, the factory setting is “OFF”.
F25 SERVO/AV REF SEL [OFF] Selects the reference servo signal during pre-read operation.
IN PREREAD MODE ON OFF:The setting of ITEM-309 is enabled.
ON: The reference servo signal is set to forced EXT. (An external reference video
input signal is used in this case.)
(Continued)