B-1
DNW-A75/A75P
Appendix B
Setting Check Sheet
It is reccommended to copy these check sheets and write down the setup conditions (switch and so on)
under the application.
If the setting is changed temporarily by changing operating condition, the setting can be reset easily.
It is recommended to attach the sheets to the unit when check, maintenance and repair.
If the unit is used frequently by changing the combination of each system, making the sheets are conve-
nient.
(Make use of the check sheets in prevention of setting error.)
Model name: DNW- Serial No.: _____________________________
. Optional hardware
SDTI output : [||] Not installed
[||] Installed (BKNW-118)
[||] Installed (BKNW-124)
. Firmware
SY1 ROM version: ____________________________
SY2 ROM version: ____________________________
SY3 ROM version: ____________________________ (When the BKNW-124 is used.)
SV1 ROM version: ____________________________
DT ROM version: ____________________________
. RS-232C baud rate: bps
. Hours meter
Write down the value of hours meter when checking, servicing, and maintaining.
ITEM Date Hours meter
H01: OPERATION HOURS /
H02: DRUM RUNNING HOURS /
H03: TAPE RUNNING HOURS /
H04: THREADING COUNTER /
H12: DRUM RUNNING HOURS(Resettable) /
H13: TAPE RUNNING HOURS(Resettable) /
H14: THREADING COUNTER(Resettable) /
H15: TTP FAN OPERATION HOURS(Resettable) /
To Next Page
Loading...
