1-26
DNW-A75/A75P
1-13. Settings and Adjustment when External Equipment is Connected
1-13. Settings and Adjustment when External Equipment is Connected
1-13-1. Settings for Time Code
Set the TC GENERATOR switches on the upper control panel as follows.
Case TC GENERATOR switch Setting Remarks
When editing with an INT / EXT INT
editor (BVE-2000, etc.)
PRESET / REGEN PRESET
capable of the 1st edit
FREE RUN / REC RUN FREE RUN
When editing with direct INT / EXT INT The setup menu ITEM-610:
machine-to-machine
PRESET / REGEN PRESET
REGEN CONTROL MODE
(VTR-to-VTR)
FREE RUN / REC RUN REC RUN
must be set to “AS&IN”.
1-13-2. VTR Constant Values Settings of Editor
Set the VTR constant values according to the table below when the editor which needs the setting of VTR
constant values is connected. Moreover, the change of VTR constant values are required when the 525/
625 system is switched by setup menu of this unit.
VTR CONSTANT 1 VTR CONSTANT 2
Model name 525/625 Data No. Data No.
12345678 12345678
DNW-A75 525/60 B0 46 00 96 07 07 03 8A
*
0A 07 FB 00 81 3D FF 5A
DNW-A75P 625/50 B1 46 00 7D 07 07 03 8A
*
0A 06 FB 00 83 4B FF 4B
*: Set the data of No.8 of the VTR CONSTANT 1 to “0A” for the following editors.
. BVE-900 ROM versions earlier than 1.08
. BVE-600 ROM versions earlier than 1.01
n
When remote-controlling this unit by the editor, set the setup menu ITEM-401: FUNCTION MODE
AFTER CUE-UP to “STOP”.
To Next Page
Loading...
