B-16
DNW-A75/A75P
625/50
ITEM-900 series: Digital process parameter
ITEM Factory setting Current Bank 1 Bank 2 Bank 3 Bank 4
903: FREEZE MODE FIELD
904: FREEZE CONTROL FROM KEY PANEL MOMNT
905: AUTO FREEZE CONTROL DIS
906: STOP FREEZE CONTROL DIS
911: NO COMPRESSION LINE OFF
914: SDTI-CP OUTPUT BIT RATE 50I
(When BKNW-124 is used only.)
915: SDTI-CP OUTPUT FORWARD ERROR ON
CORRECTION
(When BKNW-124 is used only.)
ITEM-F00 series: Adjustment use only
This series is not necessary to setting.
In the normal operation, use the factory settings.
ITEM Factory setting Current Bank 1 Bank 2 Bank 3 Bank 4
F01: AUDIO NR IN SP MODE ON
F02: EMERGENCY TAPE PROTECTION ENA
F13: TRACKING CONTROL VIA SEARCH DIAL OFF
F16: DEVICE TYPE MODIFY 0
F21: PROCESS CONT VR ON
*1
F25: SERVO/AV REF SEL IN PREREAD MODE OFF
F34: STOP PINCH OFF TIME 20M
*2
F35: AUDIO DITHER ON
*1: When the SY1 ROM’s version is earlier than 1.33, the ITEM-F21’s factory setting is “OFF”.
*2: When the SY2 ROM’s version is earlier than 1.40, the ITEM-F34’s factory setting is “5M”.
ITEM-G00 series: Shot mark operation parameter
ITEM Factory setting Current Bank 1 Bank 2 Bank 3 Bank 4
G01: SEARCH TYPE SELECT ALL
G02: LISTING TYPE SELECT
SUB-ITEM REC START MARK ON
SHOT MARK 1 ON
SHOT MARK 2 ON
POST MARK ON
G03: REC START MARK MODE
SUB-ITEM CRASH REC ON
ASSEMBLE ON
INSERT OFF
G04: MARK SELECT IN REC/ASSEMBLE SHOT1
To Next Page
Loading...
