2-31
DSR-70/70P
B 3x5
PWH 2.6x5
CN1
CN2
CN201
CN202
PWH
2.6x5
PWH 2.6x5
Harness
protector
Board mounting table assembly
MB-804 board
14.Remove the two connectors (CN1 and CN2) from the MB-804 board.
15.Remove the seven screws and remove the RP frame assembly.
16.Remove the screw securing the harness protector. Remove the remaining three screws securing the board mounting
table assembly. Remove the screw securing the MB-804 board. Remove the MB-804 board together with the board
mounting table assembly.
17.Remove the harnesses from the two connectors (CN201 and CN202) on the MB-804 board.
18.Remove the four screws from the rear of the MB-804 board. Remove the board mounting table assembly.
Note when re-attaching the MB-804 board :
Attach the MB-804 board not to pinch the harness.
19.Attach the MB-804 board by reversing the removal procedure.
To Next Page
