2-45
DSR-70/70P
. REC
. When the reel table is on the S position:
While pressing the record proof switch on the right
side of the T side reel table, press both the
[PLAY] key and the [REC] key.
The pinch roller is pressed against the capstan shaft
to enter REC status.
When the record proof switch is released, the REC
status is released and the recorder returns to PLAY
status.
. When the reel table is on the standard position:
While pressing the record proof switch on the right
side of the T side reel table, press both the
[PLAY] key and the [REC] key.
The pinch roller is pressed against the capstan shaft
to enter REC status.
When the record proof switch is released, the REC
status is released and the recorder returns to PLAY
status.
. UNTHREADING
Press the [EJECT] key.
The threading ring rotates to enter the unthreading
mode.
The threading ring moves to the specified position to
complete the unthreading.
. Switching the MINI or STD position of reel size
without cassette compartment.
(1) Without a cassette tape, turn on the switch
S101-1/SV-203.
(2) Press the [PAGE] key on the control panel.
Every pressing toggles between the MINI and the
STD reel positions.
Note : Make sure to turn off switches S101-3 and 4 on
the SV-203 board after the adjustment.
To Next Page
Loading...
