EasyManuals Logo

Spacelabs qube User Manual

Spacelabs qube
156 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #120 background imageLoading...
Page #120 background image
www.spacelabshealthcare.com
12-6
XPREZZON
AND QUBE
O
PERATIONS MANUAL
M ONITOR SETUP
Local Config
Use the settings on the Local Config tab to:
Select a subset of parameters for display
Change the color used to display parameter waveforms
Change the order in which parameters show on the display
Determine how a parameter is shown: as numerics only or as numerics and a
waveform
Restore factory defaults for all display configurations
In the monitor’s default configuration, parameters show in order of their priority.
The highest priority shows at the top of the display with the number 1. Factory-
default colors and priorities show in the table below.
You can save up to five different display configurations for parameter waveforms,
and you can change the names of the configurations. The default names are 1, 2, 3,
4, and 5.
Depending on the Parameter Set selection, the parameter list will show all
parameters or only the parameters that are currently being monitored.
Figure 12-5 Local Config tab

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Spacelabs qube and is the answer not in the manual?

Spacelabs qube Specifications

General IconGeneral
Display TypeLCD
ConnectivityEthernet
Mounting OptionsWall mount, roll stand
Power SourceAC
CompatibilitySpacelabs
Operating Temperature10°C to 40°C
Storage Temperature-20°C to 60°C
Humidity Rangenon-condensing

Related product manuals